| Specifications: |
| Input
Voltage: |
115
Vac,
380 Hz to 800
Hz |
| Normal: |
105 Vac to 125 Vac |
| Abnormal: |
95 Vac to 130 Vac |
| Input
Current: |
3.6 Amps typical at
115 Vac & at FL, .4 Amps @ NL |
| Output
Voltage: |
4-28 Vdc regulated - Grounding Pin
G (Up) or Pin A (Down) |
| Output
Current: |
10 Amps continuous |
| |
15 Amps
intermittent |
| Regulation: |
2% for load, 1% for
line and 2% for temperature |
| Response
Time: |
10mSec
typical |
| Overload(OL): |
Deliver 110% output
power for 2 hours |
| Thermal: |
The unit shuts down for thermal overload
exceeding 105 °C
temperature inside |
| Protection(OL): |
Withstands without
damage or degradation load exceeding 110% to an output short circuit. Unit delivers rated
output power upon removal of the overload condition |
| Protection(SC): |
Under a output short
circuit condition, the input and output currents pump and the currents are limited to safe
values. |
| Control: |
The output voltage is increased by grounding pin
G and decreased by grounding pin A. When
the ground is removed (OFF) the output voltage stops changing. The total time it takes from BRT to DIM (or DIM to BRT) using a
continuous grounding is about 7 seconds. For faster and smoother control, apply grounding On and Off at
appropriate rate by hand until a desired brightness or dimming is
obtained. A minimum duration
of one millisecond grounding is required to advance the output voltage one
increment. There are total of
64 increments from full bright to dim or dim to full bright.
(See Output Voltage Control Graph) |
| Efficiency: |
85%
Typical |
| Temperature: |
-55° C to +71° C |
| Altitude: |
55,000FT |
| Cooling: |
Forced air cooling (fan used) and thermal
conduction through bottom plate |
| Finish: |
Gold iridite per
MIL-C-5541 & black paint |
| Weight: |
3.5 LBS (1.59 kg) |
| Size: |
4.30 W x 6.87 L x 2.75 H
inches
Less protrusion of
connector and screw 109.2 W x 174.6 L x 69.9 H mm heads |
| Compliance: |
FAA
TSO-C71 |
| Environmental: |
By test, design similarity and/or design analysis
per:
RTCA DO-160D
F2VBBB[STX]EWXDFSAEAZZRL[XXC1]XXA |
